OEM wet end for the Waterway executive hot tub pump range. The 2.50" suction on these wet ends allows for a greater intake flow of water.
Fits a 2.5" suction union and a 2.0" discharge union.
This wet end will fit, both European (finned) and American (smooth) style 48 frame motors.
Top Tip: 1.5", 2.0" & 2.5" union connection sizes are just terms coined by the hot tub industry, the actual outside diameter of a pump connection is as follows.
|Wet End HP||4.0 HP|
|Union Connection Ref||2.5 " (Inch)|
|Configuration||Center Suction, Side Discharge|
|Connection Diameter||79mm x 93mm|
|Thread Type||Male - Buttress|
|Impeller Part No.||310-4200|
|Impeller Diameter||106 mm|
|Impeller Vane Gap||12|
|Impeller Dot Colour||Green|
|Impeller Hp Rating||3.0HP|
|Shaft Seal Type||PS-1000|
|Spare Parts Available||Yes - See Spare Parts Tab|
There are currently no questions for this product.