Direct replacement wet end complete with shaft seal for WP200 pumps manufactured after 2008.
** 2008 LP & WP pumps and wet ends are manufactured with a shorter suction (approx. 15mm) and discharge port (approx. 30mm). You may find on some hot tubs with very rigid plumbing that the newer versions will not line up with pipework. The wet end faceplate moulding is different and they are also "open" on the rear of the wet end casing as opposed to the pre 08 wet ends which are encased. SEE IMAGES.
If you are replacing a pre '08 version we are finding that the Waterway Executive equivalent tends to fit better.
|Union Connection Ref||2.00 Inch|
|Configuration||Center Suction, Side Discharge|
|Thread Type||Male - Buttress|
|Impeller Diameter||107 mm|
|Impeller Vane Gap||11.5 mm|
|Shaft Seal Type||Type A|
|Spare Parts Available||Yes - See Spare Parts Tab|
Good product, does exactly as expected, competitively priced. I Used this to replace a leaking wet end on a Davey pump. I had to also change the pump unions As Davey are non standard. Only four stars due to delivery issues.
There are currently no questions for this product.