The HydroAir HA350 pump range is our most popular selling bath pump. Their versatility makes them a popular choice if you are replacing a whirlpool bath pump that you cannot get a like for like model. The HA350 range will also replace many older HydroAir pumps. They are also a great unit to replace some Chinese filtration/whirlpool pumps.
Silent running motors coupled with either self drain or centre suction wet ends make for energy efficient compact pumps. All models are fitted with a pneumatic (air) switch so on/off operation is possible either with air buttons or electronic controls. For detailed measurements and specification see documents in the downloads tab. Unions sold seperatly
*DRP is a saftey feature which stops damage to the pump shaft seal caused by running a pump without adequate water supply.
|Dimensions L x W x H||334x132x171mm|
|HEAD - H max||11m|
|FLOW - Q max||24m³h|
|Voltage / Frequency||220-240V / 50Hz|
|Amp Draw||3.1 A|
|Power - P1||0.98 kW|
|Cord / Plug Type||Bare Wire|
|Union Connection Ref||1.50 Inch|
|Configuration||Low Suction, Center Discharge|
|Thread Type||Male - Buttress|
|Spare Parts Available||No|
1.5", 2.0" & 2.5" union connection sizes are just terms coined by the hot tub industry, the actual outside diameter of a pump connection is as follows.
There are currently no questions for this product.