The LX WP series hot tub pumps are one of the most common two speed pumps used on Chinese manufactured hot tubs and swim spas as well as many other newer hot tub and swim spa brands appearing on the European market. The WP series of pumps will often serve as a circulation and booster pump, the low speed will circulate to heat and run filter cycles while the high speed will deliver a higher volume of water through hot tub jets. If you require a 1 speed pump from LX this would be the LP pump series (please see our other listings).
The WP series is also the pump of choice for both Jacuzzi and Sundance spas, replacing the discontinued Theramax pumps and can also be used to replace similar higher priced pumps from other manufactures at a more economical price.
The LX WP250-II - Spa Pump Post 2008 - 2 Speed is a direct replacement for LX WP250 Two Speed Spa Pump with 2.00" connections manufactured after 2008**.
**IMPORTANT NOTE: 2008 LP & WP pumps and wet ends are manufactured with a shorter suction (approx. 15mm) and discharge port (approx. 30mm). You may find on some hot tubs with very rigid plumbing that the newer versions will not line up with pipework. The wet end faceplate moulding is different and they are also "open" on the rear of the wet end casing as opposed to the pre 08 wet ends which are encased. SEE IMAGES.
|Dimensions L x W x H||460x250x305mm|
|Type||2 Speed - Circ + Boost|
|HEAD - H max||16 / 3.5m|
|FLOW - Q max||670 / 300lpm|
|Union Connection Ref||2.00 Inch|
|Configuration||Center Suction, Side Discharge|
|Thread Type||Male - Buttress|
|Impeller Part No.||B351-21|
|Impeller Vane Gap||11mm|
|Shaft Seal Type||Type A|
|Spare Parts Available||Yes - See Spare Parts Tab|
1.5", 2.0" & 2.5" union connection sizes are just terms coined by the hot tub industry, the actual outside diameter of a pump connection is as follows.
There are currently no questions for this product.